Cloud-electronics SS16 Uživatelský manuál stáhnout pdf (Strana 5)

4 Sub Station 16-R: Installation and operation manual

When mounted to framework the RH-8 should be positioned at 45

(see left hand diagram

below), Ideally the RH-8 should also be positioned to one side of the user instead of directly in

front (See right hand diagram below)

When mounted directly on to a wall or perhaps the bulkhead of an exercise machine, it may be

preferable to hard wire a cable directly to the RH-8 using its internal screw terminals, a diagram

and wiring information for this are shown on the following page.

Cable for Hard Wiring an RH-8 to a Sub Station 16-R

Cable Information for Hard Wiring the RH-8

RH-8 (Screw Terminals) Sub Station 16-R (RJ45) CAT 5*

Pin 1 Pin 8 Brown/White

Pin 2 Pin 7 White/Brown

Pin 3 Pin 6 Green/White

Pin 4 Pin 5 White/Blue

Pin 5 Pin 4 Blue/White

Pin 6 Pin 3 White/Green

Pin 7 Pin 2 Orange/White

Pin 8 Pin 1 White/Orange

*The CAT 5 colour is described as the dominant colour first with the tracer second.

7 WP-8 Installation

The WP-8 is a dedicated wall-mounting unit that has all of the

features of the RH-8 and provision for low power speakers.

The module is primarily aimed at scenarios such as tanning

suites and treatment rooms where users may wish to listen to

music. The WP-8 has two low impedance, low power speaker

outputs each with a different operation:

• The first is a normal low impedance speaker output.

• This second provides a similar low impedance output that is

disconnected when headphones are connected to the WP-8.

The WP-8 should be wired directly to the equipment rack

using unscreened ‘Category 5’ cable (4 pair CAT 5), an IDC

insertion tool will be required to connect the WP-8 to the CAT-

5 cable. Cable length should not exceed 100m (328ft).

16-07-02 V2.1

1 2 3 4 5 6 7 8 9

Žádné komentáře

Cloud-electronics SS16 Uživatelský manuál Strana 5